Michem® Flex P2300

Brand Family Overview

Mold Release is a solventborne polyethylene emulsion that eliminates the high stress between a mold and the molded part, typically used for ceramics. It allows for movement and shrinkage of the part during processing and subsequent temperature fluctuations. With Mold Release, the part releases clean.

See more Mold Release products.


Primer for film, metalized film, printed film, and paper substrates promoting excellent adhesion to extrusion coated resins resulting in high bond strength for dry and low moisture contents. It creates very strong adhesion between treated film and PE extrudate. It may also be used on film substrates to promote adhesion to liquid top coats such as Michelman heat seal coatings and acrylic coatings.


Water based primer for extrusion coating.

Performance Attributes

This product is used in many applications including the following:

ApplicationProperties Imparted
Extrusion Coating Primersadhesion for film

See more products recommended for Extrusion Coating Primers.
Physical Properties

These physical properties are typical but should not be considered specifications.

AppearanceClear liquid
Percent Non-Volatile4.5 - 5.5
Brookfield Viscosity (cps, mPa·s) <50
Spindle Number1

Site of Manufacture (and Product Code)

CIN (MFP2300)
AUB (MFP2300.E)
SNG (MFP2300.S)

Application Data

Michem® Flex P2300 may be applied via flexo, gravure or smooth roll coater. Dilute 1:1 with water prior to use. Corona or flame treat substrates prior to priming and dry thoroughly with hot, circulating air. This product is best for in-line processes. Recommended application weight for film substrates is 0.025 - 0.075 dry g/m2 (0.5-1.5 wet g/m2). EZ Cup Viscosity - #2 Cup, 16-18 sec.


Handle in accordance with good industrial hygiene and safety practice.